Use and maintenance manual 03.01 – 22/06/2016 29
RECHARGING BATTERIES
The feeder is placed inside the passenger compartment, under the
seats, and to carry out the recharge, all you have to do is link Birò to a
normal, 220v household outlet, by using the “spiral” wire provided.
The feeder turns on and, on the luminous display,
the real battery tension is visualised. After a few
seconds, the pilot light corresponding to the
battery charge state (2) turns on, and the feeder
gradually begins to provide power. By pressing
button (4) you cyclically visualise the information
indicated in the box (1): power provided (A),
charge tension (U), charge time (H), Total
distributed current and Total power distributed
(C and E). The charge cycle is over when
the green led is on. In the case of pure lead
batteries, after the connection to a stoker, is
necessary to put on the switch positioned in the
rear trunk in order to start the charging.
! WARNING During the charge, the feeder requires plenty of ventilation
for cooling. Do not obstruct, the slits placed above the display of the
feeder in any way whatsoever.
To Next Page
Loading...