Estrima BIRO - Rear Wheel Puncture Repair

Use and maintenance manual 03.01 – 22/06/201646
Type of tyres
The tyres that must be mounted on Birò are:
Front 130/60–13 55 J Rear 130/60–13 55 J
as an alternative: Front 130/60–13 53 M Rear 130/60–13 53 M
as an alternative: Front 130/60–13 60 P Rear 130/60–13 60 P
as an alternative: Front 130/60–13 61 L Rear 130/60–13 61 L
as an alternative: Front 145/60 R13 65 T Rear 145/60 R13 65 T
as an alternative: Front 145/60 R13 65 T Rear 175/50 R13 72 V
The front tyres are tubular.
! WARNING The mounting of inadequate tyres may jeopardise your
driving and vehicle stability, and may be the cause of accidents, with
ensuing grave injuries or even death.
IN CASE OF A PUNCTURE TO THE BACK WHEEL
WARNING When scooter type tyres are tted, do not loosen the
#3 screws that are tightened deeper.
In the case of a puncture of the rear
tyre, proceed as follows to repair it:
1. Deate the tyre completely, if this
has not been done already.
2. Undo the 15 screws that hold
the tyre locking ring.
3. Remove the ring.
4. Repair or replace the tyre.
5. Repeat the operations from 1. To
3. In reverse sequence in order
to t back or replace the ring.
Then turn the 15 screws back in
position and inate the tyre.