Use and maintenance manual 03.01 – 22/06/201648
Substituting the low-beam headlight
To substitute the bulb proceed as follows:
1. Unhook the connector by lifting both the
little tongues A.
2. Rotate bulb B anti-clockwise until it
unhooks.
3. Pull and take out the bulb.
4. Substitute the bulb and, to remount it,
proceed inversely.
Never touch the glass part of the bulb with
your hands.
Type of bulb: H8 12V 35W
Substituting rear lights
To substitute the bulb proceed as follows:
1. Pull the bulb A in the direction indicated by
the arrow until it comes away completely.
2. Disconnect the connector of the bulb and
substitute it.
3. Carry out the reverse procedure to remount it.
Be careful in remounting the bulb correctly (up
to the last notch of the rubber top/cap that
envelops the bulb) since, otherwise, there might
be water inltrations.
Type of bulb: T10 12V 5W
To Next Page
Loading...