Estun ProNet Plus Series - Page 212

ProNet Plus Series AC Servo User's Manual
- 210 -
Parameter
No.
Description
Setting
Validation
Control
Mode
Function and Meaning
Pn702
Reserved
—
—
—
Pn703
Hex
After restart
ALL
Pn703.0: Reserved
Pn703.1: Synchronous frame early detection
[0]Close
[1]Open
Pn704
EtherCAT
communication
contact
After restart
ALL
EtherCAT Aix address of communication
Pn705
32 bit 1st electronic
gear numerator (H)
After restart
ALL
The parameters are valid,when Pn009.2=1.
The electronic gear enables the reference pulse to
relate with the servomotor travel distance, so the host
controller doesn't change the mechanical deceleration
ratio and encoder pulses. In fact, it is the setting of
frequency doubling or frequency division to the
reference pulses.
)70810000*707(min
)71010000*70970610000*705(
PnPnatorDeno
PnPnorPnPnNumerator


Pn706
32 bit 1st electronic
gear numerator (L)
After restart
ALL
Pn707
32 bit electronic gear
denominator (H)
After restart
ALL
Pn708
32 bit electronic gear
denominator (L)
After restart
ALL
Pn709
32 bit 2nd electronic
gear numerator (H)
After restart
ALL
Pn710
32 bit 2nd electronic
gear numerator (L)
After restart
ALL
Pn840
Hex
After restart
ALL
Pn840.0 Encoder model selection
[0]-[E] Reserved for manufacturer
Pn840.1 Motor designing sequence
[0]-[1] Reserved for manufacturer
Pn840.2 Servo drive model selection
[E] 0.05kW servo drive
[F] 0.1kW servo drive
[0] 0.2kW servo drive
[1] 0.4kW servo drive
[2] 0.75kW servo drive
[3] 1.0 kW servo drive
[4] 1.5kW servo drive
[5] 2.0kW servo drive
[6] 3.0kW servo drive
[7] 5.0kW servo drive
[8] 7.0kW /7.5kW servo drive
[9] 11kW servo drive
[A] 15kW servo drive
[B]22kW servo drive
Pn840.3 Reserved (For factory using)