ETAS ES582.2 - 3 Commissioning; Preparing to Install; Checking System Requirements; DVD

16 | Commissioning
ETAS ES582.2 | User Guide
3 Commissioning
This chapter contains information about the following topics:
• Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
• Preparing to Install . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
• Verifying the Installation of the USB Driver. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
• Establishing the USB Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
• Updating the USB Driver. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
• Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
3.1 Assembly
3.2 Preparing to Install
The ES582.2 can be installed under plug & play-compatible operating systems
(min. Windows 10). After installing the drivers, the ES582.2 module can be
inserted/removed at any time.
3.2.1 Checking System Requirements
Check whether your PC meets the system requirements (see also 5.9 on page 29).
Administrator rights are required for the installation of the USB driver on the PC. If
necessary, contact your system administrator.
3.2.2 DVD
The supplied DVD includes:
- USB driver for the ES582.2 with installation wizard
NOTICE
Damage to the electronics due to potential equalization
The cables' shield may be connected to the housing, the ground or the ground
for the product's power supply. If there are different ground potentials in the test
setup, equalizing currents can flow between the products via the cables' shield.
Take account of different electric potentials in your test setup and take appro-
priate measures to prevent equalizing currents.
WARNING
Risk of injury due to inadequate fastening
- Secure the product so that it does not move uncontrollably.
- Only use carrier systems and fastening materials that can accommodate the
static and dynamic forces of the product and are suitable for the ambient
conditions.
NOTE
The latest USB driver must be installed on the PC in order to operate the ES582.2
module.