ETAS ES582.2 - Assembly

7 | Safety Notices
ETAS ES582.2 | User Guide
1.3 Assembly
Only install, connect, disconnect and cable ETAS products and components when
they are de-energized.
Installation location
Install the product on a smooth, level and firm surface.
Securing the Product
The housing must not be damaged while securing the product.
Ventilation
- Protect the product against direct solar radiation and other sources of heat.
- Ensure that there is sufficient air circulation for efficient heat exchange.
CAUTION
CAUTION indicates a hazardous situation of low risk, which may result in minor or
moderate injury if not avoided.
NOTICE
NOTICE indicates a situation, which may result in damage to property if not
avoided.
WARNING
The following product is a Class A piece of equipment: ES582.2
This piece of equipment may cause radio interference in living areas. In this case,
the user may be required to take appropriate measures.
NOTICE
Damage to the electronics due to potential equalization
The cables' shield may be connected to the housing, the ground or the ground
for the product's power supply. If there are different ground potentials in the test
setup, equalizing currents can flow between the products via the cables' shield.
Take account of different electric potentials in your test setup and take appro-
priate measures to prevent equalizing currents.
WARNING
Risk of injury due to inadequate fastening
- Secure the product so that it does not move uncontrollably.
- Only use carrier systems and fastening materials that can accommodate the
static and dynamic forces of the product and are suitable for the ambient
conditions.