ETAS ES582.2 - Operation; Electrical Connection

8 | Safety Notices
ETAS ES582.2 | User Guide
1.4 Operation
Only operate the product with the latest firmware. You can find information about
updating the firmware in the user manual.
If the firmware update is not completed successfully, try it again. If a new firmware
update is not possible and the product is not functional, send the product to ETAS.
1.5 Electrical Connection
Electrical Safety and Power Supply
- Only connect the product to electric circuits with safety extra-low voltage in
accordance with IEC 61140 (devices of class III) within the voltage limits for
accessible parts as per IEC 61010-1.
- Comply with the connection and setting values (see chapter Technical
Data).
- The power supply for the product must be safely disconnected from the
mains power. For example, use a car battery or a suitable lab power supply.
- Only use lab power supplies with dual protection for the supply network
(with double/reinforced insulation (DI/RI)).
- The power supply must be suitable for use according to the ambient condi-
tions for the product.
- It is possible to discharge the vehicle battery in regular operation and long
standby operation.
- Central load-dump protection is required for operation.
Connection to the Power Supply
The product is powered via the USB. Connect the product directly to a computer's
USB interface, ETAS drive recorders or active hubs that meet the USB 2.0 specifi
-
cations, as a minimum.
De-energizing the product
1. Remove the USB cable.
2. Remove all cables from the product.
WARNING
Risk due to undefined vehicle behavior during an ECU reset
If you operate the product in combination with ETKs, the ECU must not be reset
in an uncontrolled manner.
- Only make changes when the vehicle is stationary (e.g., changes to the test
setup, changes to the ETK configuration, software updates).