29 | Technical Data
ETAS ES582.2 | User Guide
5.9 System Requirements
5.9.1 Hardware
PC with USB port
Power supply
The power supply of the product is connected via the USB port of a PC or a drive
recorder. An external power supply is not required for the module.
Prerequisite for the successful initialization of the module
Windows user rights
Ensure that you have the required Windowsuser rights for the installation of the
USB driver (administrator rights).
Additional requirements
The PC must meet the minimum requirements of the application program used
(e.g. INCA). Information about the minimum requirements for INCA is located in the
corresponding software documentation.
USB port min. USB 2.0
USB socket type A / type C
Operating system min. Windows 10
Driver ES582.2 USB driver
NOTE
The module must be operated directly on the USB connection of a PC, a drive
recorder or an active hub whose USB interface meets the requirements listed in
the table.
The use of USB cables for extending the connection between ES582.2 and PC or
drive recorder is not allowed.
NOTE
A specific USB driver must be installed on the PC for operating the ES582.2 mod-
ule (see chapter 3.3 on page 18).
To Next Page
