ETC Installation Manual
ColorSource Spot
ColorSource Spot Page 4 of 12 Electronic Theatre Controls, Inc.
Adjusting the tilt
The fixture can be tilted up and down and rotated (panned) as needed.
Step 1: Loosen, but do not remove the yoke locking knobs.
Step 2: Tilt the fixture to the desired angle.
Step 3: Tighten the yoke locking knobs.
User interface
The user interface allows you to set the start address of the fixture, and access
the stand-alone presets and sequences. After five seconds of inactivity, the
display goes dark.
Mode button
Pressing the Mode button activates the Preset/Sequence selection menu; the
last active preset or sequence plays automatically. Pressing the Mode button a
second time deactivates the selected preset or sequence. The display will revert
to show the DMX start address.
• If DMX data is present, the current preset or sequence plays in the
background and DMX data continues to take priority.
• If DMX data is lost and a preset is active in the background, the last
selected preset or sequence automatically plays.
Setting the DMX address
Step 1: Press the Mode button until the DMX address is displayed.
Step 2: Use the Up and Down buttons to select the DMX address for
the fixture.
To Next Page
Loading...
