EN 12
Make sure the unit has been installed and connected according to the
instructions in the installation instructions at the back of this manual.
Before using the appliance
The tumble dryer may still contain dust and grease from the production
process or transportation. To prevent your clothes from getting dirty,
you need to run a pilot program for the first time.
EDM207L
1. Put some clean damp cloths into the drum.
2. Plug the plug into the socket.
3. Select the 'Short' program using the program selector dial and
press the Start/Pause button.
4. After the program has finished you need to clean the fluff lint filter
and the condenser (see pages 22 and 23: 'Maintenance') and
empty the water reservoir.
EDM106B
1. Put some clean damp cloths into the drum.
2. Plug the plug into the socket.
3. Press the On/Off button.
4. Select the '1 Hour' program using the the program button and
select 'High' with the temperature button.
5. Press the Start/Pause button.
6. After the program has finished, you need to clean the fluff lint filter
(see pages 22 and 23 'Maintenance').
Checklist and preparation for drying
Read this checklist carefully to prevent problems from occurring with
the tumble dryer and your laundry getting damaged.
• Fill the drum one half or one third full. Laundry needs room to be
able to dry, and in this way the laundry is spread evenly throughout
the drum. An overloaded drum does not produce good drying
results.
• Only load properly spun laundry into the tumble dryer.
Properly spun laundry reduces drying time and saves energy.
COMMISSIONING
To Next Page
Loading...