EN 24
General
If you have any doubts about whether your tumble dryer is working
properly, this does not automatically mean that there is a problem. If
in doubt, check the points set out in the following tables or for more
information visit the web site 'www.etnaservice.nl'.
• Repairs must be performed by the service centre or a qualified
person. First check whether you are able to rectify the problem
yourself before calling Customer Service.
• If you are not able to rectify the fault yourself: remove the plug from
the socket and call Customer Service.
Noise can be caused by:
• Vibration: soaking wet clothing is heavy and makes the drum
unbalanced, knocking against its outer walls.
• Air outlet: while it is drying the tumble dryer generates steam, which
is vented through the vent pipe, which in turn produces noise.
• The sound of the timer when a drying program is running.
EDM207L fault tables
In terms of the error codes you will hear a beep every 15 minutes.
Error code Cause Solution
'E30' is flashing. Heating problem. Check the heating element
and the thermostat.
'E32' is flashing. Humidity sensor fault. Check the humidity sensor
and the printed circuit board.
'E33' is flashing. Temperature sensor fault. Check the temperature
sensor at the front.
'E34' is flashing. Temperature sensor fault. Check the temperature
sensor at the rear.
'E60' is flashing. Motor failure. Check the motor and the
printed circuit board.
FAULTS
To Next Page
Loading...