EN 20
Running a drying program
1. Plug the plug into the socket.
2. Fill the tumble dryer with laundry.
3. Select a program using the program button based on the fabric
type and the weight of the laundry (see table on page 19).
4. Select a temperature using the temperature button based on the
fabric type and the weight of the laundry (see table on page 19).
5. Where applicable, select the additional anti-crease function by
pressing the appropriate button.
▷ When you select this function, the LED comes on and the drum
rotates at intervals to reduce creasing.
6. Finally, press the Start/Pause button.
The selected program starts. The '1 Hour/Iron Dry/ Cupboard Dry/
Extra Dry' LEDs indicate what the program is doing. When the
drying program has finished, a beep sounds.
▷ After the program has finished, you need to clean the fluff lint
filter (see pages 22 and 23: 'Maintenance').
▷ When the Start/Pause button is pressed directly without
selecting a program, the tumble dryer starts automatically with
the 'Cupboard Dry' program set to the maximum temperature.
▷ The pause function is engaged when you press the Start/Pause
button for a second time. The program pauses for 3 seconds
and, if necessary, can be changed or laundry can be added/
removed. Press the Start/Pause button again and the program
continues.
Note: avoid burning yourself on hot steam when you open the
door!
Aborting a drying program
If you want to interrupt a drying program, turn the program selector dial
to position '0'.
OPERATING THE EDM106B
To Next Page
Loading...