EN 16
Dryer drum lighting (EDM207L)
The dryer drum lighting switches on when you open the door, although
you can also activate it yourself whilst drying by pressing the 'Lamp'
button.
Automatic anti-crease function
To prevent the clothes from creasing after the program has finished, the
tumble dryer will automatically rotate at intervals for 2 hours.
Running a drying program
1. Plug the plug into the socket.
2. Fill the tumble dryer with laundry.
3. Select a program using the program selector dial based on the
fabric type and the weight of the laundry (see table on page 15).
4. Optionally select an additional function by pressing the 'Start in...',
'Anti-crease' or 'Low temperature' button.
▷ Start in...: This function is used to program a delayed start time
(see page 17).
▷ Anti-crease: when you select this function, the LED is illuminated
and the drum rotates at intervals to reduce creasing.
▷ Low temperature: when you select this function, the LED is
illuminated and the program will run at a lower temperature to
protect clothing liable to shrink.
5. Finally, press the Start/Pause button.
The selected program starts. The 'Damp/Iron Dry/ Cupboard Dry/
Extra Dry' LEDs indicate what the program is doing. When the
drying program has finished, a beep sounds. Rotate the program
selector dial to '0 'to turn the appliance off.
▷ After the program has finished you need to clean the fluff lint
filter and, where applicable, the condenser (see pages 22 and 23:
'Maintenance') and empty the water reservoir.
Aborting a drying program
If you want to interrupt a drying program, turn the program selector dial
to position '0'.
OPERATING THE EDM207L
To Next Page
Loading...