EasyManua.ls Logo

ETNA EDM106B - Maintenance; Before Starting Maintenance; General; Cleaning the Fluff Lint Filter

ETNA EDM106B
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 22
Before starting maintenance
Remove the mains lead or turn off the power supply.
Warning!
Do not spray or rinse the dryer with water. Risk of short circuit!
General
Cleaning the housing and drum
Use a soft, damp cloth to clean the housing and the drum.
Do not rinse with water.
Do not use an abrasive pad / abrasive.
Do not clean with alcohol.
Leave the door open for ventilation after cleaning.
Cleaning the fluff lint filter
1. Unlock the filter: the fluff lint filter is located in the door opening.
Lift the filter up and open the filter.
2. Clean the filter: wipe the filter clean with a cloth or by hand.
3. Replace the filter. If you have cleaned the filter with a damp cloth
or in water, you must first leave the filter to dry in the sun before
replacing it.
Note:
Clean the fluff lint filter each time you use the appliance to avoid
extended drying times and unnecessary energy consumption. The
accumulated dust blocks the air circulation.
Do not use the tumble dryer without the fluff lint filter!
MAINTENANCE

Table of Contents