EN 23
Cleaning the condenser (EDM207L)
1. Allow the tumble dryer to cool.
2. Place an absorbent cloth under the service panel to capture any
excess moisture.
3. Open the service panel.
4. Push both locking levers towards one another.
5. Pull the condenser out.
6. Clean the condenser thoroughly, rinse well.
7. Clean the washers.
8. Refit the condenser.
9. Push both locking levers back in place.
10. Close the service panel.
• Clean the condenser every 5 drying cycles.
• Do not damage the condenser!
Note:
• Only clean with hot water.
• Do not use sharp objects.
• Do not use the tumble dryer without the fluff lint filter and condenser!
• During the drying process water may get between the glass and the
door seal; this does not affect the operation of your tumble dryer.
MAINTENANCE
To Next Page
Loading...