EN 30
▷ If the tumble dryer is not fitted so that it is level (the inclination
should not be greater than 2 degrees), the tumble dryer may
start to shake or switch off.
3. Fit the flexible outlet pipe.
▷ Connect one end of the flexible pipe to the rim to the air outlet
at the rear. Screw on the pipe until it locks in place.
▷ Run the other end of the flexible pipe outdoors.
The correct installation process can be seen in the following
figures.
Electrical connection
• Plug the plug into a socket, which has been properly fitted and
earthed.
• Make sure your domestic mains voltage is equal to the values on
the energy label.
• Do not use multi-gang adapters as an extension lead.
• Never touch the plug with wet hands.
• Hold the plug firmly when inserting or removing from the socket.
• If the mains lead is damaged, it must be replaced.
Note! The mains lead must be replaced by a qualified fitter.
Warning
• The tumble dryer must be connected to an earthed plug socket.
This tumble dryer is fitted with a mains lead with an earthed plug.
• The tumble dryer must be connected to a dedicated circuit.
• Make sure the connecting lead remains intact at all times.
INSTALLATION
To Next Page
Loading...