EN 26
EDM106B fault tables
In the event of the following faults, you will hear a beep for 10 seconds.
If the fault persists, the beep sounds every 16 minutes for 10 seconds.
Visual display and fault Cause Solution
The 'Extra Dry' and
'Cupboard Dry' LEDs are
flashing: overheating.
The temperature is too high. Switch off the tumble dryer
and wait until the temperature
has fallen.
The 'Cupboard Dry' and 'Iron
Dry' LEDs are flashing: door
is open.
The door has been opened
during a program.
Close the door, switch off the
alarm and restart the drying
program. The next time you
open the door should be
following completion of the
program.
The 'Iron Dry' and '1 Hour'
LEDs are flashing.
Program start sensor open. Switch off the tumble dryer
and check it. Restart when
normal.
The 'Cupboard Dry' and
'1 Hour' LEDs are flashing.
Program start sensor open. Switch off the tumble dryer
and check it. Restart when
normal.
FAULTS
To Next Page
Loading...