What to do if my ETNA KI290ZT/E02 is not working and the display is blank?
If your ETNA hob isn't working and the display is blank, it could be due to a power supply issue. Check the fuses or the electric switch to ensure a proper connection.
Why does my ETNA Hob keep blowing a fuse when I switch it on?
If a fuse blows immediately when you switch on your ETNA Hob, it's likely that the hob has been wrongly connected. In this case, you should check the electrical connections.
What to do if my ETNA KI290ZT/E02 Hob displays error code F?
If your ETNA Hob shows error code F, it means the control panel is either dirty or has water on it. To resolve this, simply clean the control panel.
What does error code E3/E4 mean on my ETNA KI290ZT/E02 and what should I do?
Error code E3/E4 on your ETNA Hob indicates that the supply voltage or frequency is different from the rated values. Turn off the hob and let it cool down until the 'H' disappears from the display. Then, switch it back on. If the error persists, call an authorised service agent.
What does error code E5 mean on my ETNA KI290ZT/E02 Hob and how to fix it?
Error code E5 on your ETNA Hob indicates that the internal temperature of the hob is too high. Turn off the hob and let it cool down until the 'H' disappears from the display. Then, switch it back on. If the same error is displayed again, call an authorised service agent.
What does error code E1 mean on my ETNA Hob and how do I fix it?
Error code E1 means that the air exhaust is blocked, possibly by paper. Ensure that the fan air exhaust is free.
Why does my ETNA KI290ZT/E02 Hob display ‘u’ when I switch on a cooking zone?
If your ETNA hob displays ‘u’ when you switch on a cooking zone, the pan you're using may not be suitable for induction cooking or its diameter is less than 12 cm. Use a suitable pan.
Why did a cooking zone on my ETNA KI290ZT/E02 Hob suddenly stop working and I heard a signal?
If a cooking zone on your ETNA hob suddenly stops working and you hear a signal, it means that the preset time has ended. Switch off the bleep by touching the + key of the timer.
Why does the display light up when the ETNA KI290ZT/E02 is activated for the first time?
Normal operation.
Why does the fan run on for several minutes after the ETNA Hob has been switched off?
Normal operation.
To Next Page
General
