What to do if my ETNA KI290ZT/E02 Hob is not working and nothing appears on the display?
If your ETNA Hob isn't working and the display is blank, it could be due to a lack of power. Check the fuses or the electrical switch to ensure they are functioning correctly. This may be caused by a defective cable or a faulty connection.
Why does the fan run on for several minutes after the ETNA Hob has been switched off?
Normal operation.
What to do if the display shows ‘u’ on my ETNA KI290ZT/E02 Hob?
If the display of your ETNA Hob shows ‘u’ when you switch on a cooking zone, it means the pan you're using isn't suitable for induction cooking or has a diameter less than 12 cm. You should use a suitable pan.
Why do my pans make noise while cooking on the ETNA KI290ZT/E02 Hob?
The noise your pans make while cooking on the ETNA Hob is due to the energy flowing from the hob to the saucepan. At high settings, this is normal for some pans and will not damage either the pans or the hob.
Why does my ETNA KI290ZT/E02 cooking zone suddenly stop working?
If a cooking zone on your ETNA Hob suddenly stops working and you hear a signal, it's likely that the preset time has ended. You can switch off the beeping sound by touching the + key of the timer.
What to do if my ETNA KI290ZT/E02 displays error code E1?
If your ETNA Hob displays error code E1, it indicates that the air exhaust is blocked, possibly by something like paper. Check to ensure that the fan air exhaust is free from obstructions.
What does error code E5 mean on my ETNA KI290ZT/E02 Hob and how to fix it?
Error code E5 on your ETNA Hob indicates that the internal temperature of the hob is too high. Turn off the hob and let it cool down until the 'H' disappears from the display. Then, switch it back on. If the same error is displayed again, call an authorised service agent.
What does error code E3/E4 mean on my ETNA KI290ZT/E02 and what should I do?
Error code E3/E4 on your ETNA Hob indicates that the supply voltage or frequency is different from the rated values. Turn off the hob and let it cool down until the 'H' disappears from the display. Then, switch it back on. If the error persists, call an authorised service agent.
What to do if my ETNA KI290ZT/E02 Hob displays error code F?
If your ETNA Hob shows error code F, it means the control panel is either dirty or has water on it. To resolve this, simply clean the control panel.
Why does my ETNA Hob keep blowing a fuse when I switch it on?
If a fuse blows immediately when you switch on your ETNA Hob, it's likely that the hob has been wrongly connected. In this case, you should check the electrical connections.
To Next Page
General
