EUFY Clean G35+ - Preparation

10 EN
Preparation
1
Remove the foam blocks beside the bumper
before use.
2
Install the side brush before use. You will
hear a click when the side brush is firmly
installed.
Click
3
Turn on the main power switch on the right
side of RoboVac.
4
Install the self-empty station in a location
that RoboVac can easily access. Place it
against a wall, and on a hard, level surface.
.
5
Peel off the stickers on the protective pad
and install it under the self-empty station.
Make sure the protective pad is firmly
attached to the floor.
1
2
6
Remove objects within 1.6ft / 0.5m to
the left and right sides and within 4.9ft
/ 1.5m of the front of the self-empty
station.
1.6ft / 0.5m
1.6ft / 0.5m
4.9ft / 1.5m
7
Connect the power cord to the Self-
Empty Station and a wall outlet.