Eumig MARK-S SUPER 8 - The Projection Lamp

Changing the projector lamp (100 W/12 V halogen lamp, life 50 hours)
Remove lid of lamp hous- Hinge the protective plate down A new lamp can now be
ing. and pull out the projection lamp inserted.
(when cool) in an upward direc-
tion. .
Never touch the lamp with your bare fingers. Every finger mark will be burnt into the- sleeve of the halogen
lamp, and this reduces the light output.
If you should have accidentally touched the lamp, clean immediately with a clean cloth damped with methy-
lated spirit. ;
The lamp filament is very sensitive to knocks, both during projection and while cooling down.
Please note: Operating at too high a voltage considerably reduces the life of the lamp. (If necessary, set the
voltage adjustment to one step higher).
22