Eumig MARK-S SUPER 8 - Music from Radio;Phono Input

Music from radio/phono input
1. Insert the film.
2. Switch on sound head (green indicator lamp).
3. Connect radio, record player or tape recorder to socket [a).
4. Set main switch to “projection".
5. When the part of the film has been reached where recording should commence, press red recording key
(red indicator lamp).
Recording level control
The “manual“ recording level control is situated above the radio/phono socket. The
radio/phono-input is designed to cater for the normal output impedance of the av-
erage, radio, record player or tape recorder. The level of the sound source being used
can be adjusted through the recording level control, which is initially set by the manu-
facturers to an average setting. This setting should be regarded as a general standard
If a test recording should indicate that the replay volume is too low, then turn the
recording level control very slightly in a clockwise direction.
2
If the recording sounds distorted, adjust the recording level control by turning it in an
anti-clockwise direction.
«
The recording level setting can be checked through a head-set. The scale on the
recording level control serves to enable you to memorise and repeat any predetermi-
ned setting.
18