Eumig MARK-S SUPER 8 - To the Mains; Changing to a Different Mains Voltage; Adjusting the Mains Frequency to 50 or 60 C;S

Before connecting
the EUMIG MARK-S SUPER 8 to the mains
Check the mains voltage and type of current of your elec-
tricity supply. The EUMIG MARK-S SUPER 8 is designed
for use with 110—250 volt A. C. mains, and can be switched
to either 50 or 60 cycles per second.
Voltage selector A and frequency selector D are generally set
to the mains voltage and standard frequency of the country of
purchase.
The running speed set by the manufacturer corresponds with
the standard running speed of a SUPER 8 movie camera.
Should your electricity meter indicate a voltage different
from that for which the projector is set, then the voltage
selector must be adjusted accordingly.
Changing to a different mains voltage. (Only with the unit dis-
connected from the mains!)
1. Undo the two screws B.
2. Remove the back cover.
3. Pull out red voltage plug C in an upward direction, and
plug into the correct position.
4. Replace the back cover.
Adjusting the mains frequency to 50 or 60 c/s
1. Pull out blue plug D in an upward direction and plug into
the correct socket.
2. Adjust the running speed of the projector to the changed
frequency. Sliding lever E is moved in such a way that
the correct frequency can be read above the valves.