EVBox Audi Wallbox - Configuration Manager

21
Conguration Manager
Read these instructions before installation and conguration of the Audi Wallbox.
The local conguration of the Audi Wallbox is only possible for the connective versions
of the wallbox, i.e. Audi Wallbox plus and Audi Wallbox pro. The Audi Wallbox is not
equipped with a communication board and therefore, not capable to oer any connectivity
functionality.
Distinction of the Conguration
Manager and the myAudi app
The Audi Wallbox's Conguration Manager
is a local conguration tool with the main
objective to establish the Aud Wallbox's con-
nection to the Audi Backend over the internet
and if available, an energy management sys-
tem. In addition, the Conguration Manager
provides multiple functions to perform local
settings and troubleshooting.
The Conguration Manager does not intend
to give insight into the Audi Wallbox’s usage
or charging management. These functions,
e.g. granting access for specic charging
cards or gain insight into the charging
history, are to be found in the myAudi app.
The Conguration Manager is intended for
users during initial installation of the Audi
Wallbox as well as for certied electricians
during maintenance and troubleshooting.
Conguration Sticker
A Conguration Sticker is delivered with eve-
ry Audi Wallbox plus and Audi Wallbox pro.
This sticker contains all credentials that are
unique to each Audi Wallbox. These unique
credentials are network parameters, pass-
words, and other codes. The gure below
provides an overview of the Conguration
Sticker, and the table provides an explana-
tion of the data listed on the sticker.