47
Forward-facing Installation with Seat Belt
5. Remove all slack
from the seat belt.
Using your full weight,
push the child restraint
firmly into the vehicle
seat
while tightening
seat
belt to remove excess
slack.
6. Install locking clip,
if necessary.
You MUST use a locking
clip if your vehicle has:
Lap/shoulder seat belt
combination that has a
buckle tongue that slides
freely along the belt
without locking into
place; OR
Seat belts equipped with
an emergency
locking retractor (ELR).
Locking Clip
installed properly
Some ELR vehicle belts can be switched so that they lock
when tightened. It may not be necessary to use a locking
clip in these situations.
Consult your vehicle owner’s manual before in-
stalling the locking clip.
To see an example of seat belt types and to properly
install a locking clip, go to p. 64.
13 mm
(0.5 inch)
Forward-facing
To Next Page
Loading...
