Evenflo Tribute - Positioning the Recline Stand for Rear-facing Use; Installing the Child Restraint Rear-facing with Lower Anchor Connectors

18 19
• ONLY use for securing child restraint to lower anchor
bars.
• ALWAYS read and follow exactly the instructions
which accompany your vehicle and child restraint.
• NEVER attach two hooks to one vehicle lower anchor
bar.
• DO NOT use the vehicle seat belts to install a child
restraint when using the Lower Anchor Connector
Assembly.
• This Lower Anchor Connector Assembly is intended to
be used ONLY as described in these instructions.
Serious injury or death may result from misuse.
• ALWAYS be sure that the Lower Anchor Connector
hook is fully engaged onto the Vehicle Lower Anchor
Bar by pulling hard on the Lower Anchor Connector
strap. If it is not totally engaged, the Lower Anchor
Connector Assembly will not secure your child
restraint. Serious injury or death may result.
• To avoid a strangulation hazard, you MUST store
the unused lower anchor connector assembly, with all
slack removed, in storage area on the back of the seat.
Roll or fold excess lower anchor connector strap and
secure with a rubber band to prevent serious injury to
vehicle occupants.
• In addition to these instructions, read and follow your
vehicle owner’s manual regarding installation of child
restraints and LATCH. If there is a discrepancy, follow
your vehicle owner’s manual.
WARNING
Installing the Child Restraint
Rear-facing with
Lower Anchor Connectors
La flèche DOIT être à niveau
avec le sol lors de l’utilisation
en orientation face à l’arrière
ARRIÈRE DU VÉHICULE
The child restraint MUST be in the Recline position for
rear-facing use. Child MUST weigh 2.3 – 18 kg (5 – 40 lbs).
If the level arrow is not parallel to the ground, use a
tightly rolled towel or small blanket
B
beneath the
front edge of the child restraint.
You need to provide enough recline for an infant’s
head to lie back comfortably.
Rear-facing Recline
B
A
Lift the child restraint and
flip the recline stand
A
toward the front, as
shown, to the Recline
position.
Arrow MUST be level
with ground when used
Rear-Facing
REAR OF VEHICLE
Positioning the Recline Stand for
Rear-facing Use
IMPORTANT: Infants may have difficulty breathing
when in a sitting position. Make sure they recline enough
for their head to lie back comfortably and safely. Failure
to properly recline the child restraint could increase the
child’s risk of serious injury or death.
Level Arrow
Rear-facing
LATCH is a system for attaching the child restraint to
your vehicle seat. It is to be used in place of your
vehicle’s seat belts, and can be used in vehicles with
LATCH anchors. Your vehicle owner’s manual may refer
to this system as ISOFIX, Universal Anchorage System
(UAS), or Lower Universal Anchorage System.