14 15
Place baby in the child restraint. The baby’s back and
bottom should be flat against the restraint. If there is a
gap, the baby will not be comfortable.
Align the two sides of the
chest clip
A
and snap
them together. The chest
clip must be positioned
at armpit level.
The harness straps must be
snug against the child. A snug
strap should not allow any slack.
It lies in a relatively straight line
without sagging. It does not
press on the child’s flesh or push
the child’s body into an unnatural
position. Check the harness
straps near the shoulders for
slack. You should NOT be able
to pinch the harness (see illustration).
Adjust as needed.
Slide each harness strap
over the child’s shoulders.
Insert the buckle tongues into
the buckle. Pull up on the
harness strap to ensure the
buckle tongues are engaged.
2
3
1
Securing Your Child in the Child
Restraint
Using the 2-piece Chest Clip
A
Important Information
Push the release button
A
and pull the chest clip
apart.
Press the red buckle
release
B
, and remove
both buckle tongues
C
.
A
Using the 2-piece Chest Clip
B
C
Removing Your Child from the
Child Restraint