48 49
Installing Child Restraint Forward-facing
in Aircraft
A
3
Fasten the aircraft seat belt
A
.
The aircraft seat belt must be as tight as possible. Route
the excess aircraft seat belt strap
C
back through the
forward-facing belt path
D
opening, as shown above.
Using your full weight, push the child restraint firmly
onto the aircraft seat
while pulling on the excess
seat
belt strap to tighten.
Note: Because of the fixed length of aircraft seat belts, the
belt buckle could be behind the child’s back after tightening
the belt. For your child’s comfort, Evenflo recommends
cushioning the child’s back by placing a small pillow or
folded-up blanket, or a folded-up jacket, over the belt buckle.
Check your work. Reconnect the seat pad to the front
of the child restraint. Try to move the child restraint in
all directions. If you can move the restraint more than
25 mm (1 inch) from side to side or front to back at the
forward-facing belt path, the aircraft seat belt is not tight
enough, and you MUST install again until the seat belt
is tight.
C
D
4
To order replacement parts you can order on-line at
www.evenflo.com or contact Evenflo. When you contact
us, please have the product model number and date of
manufacture (found on the back of the child restraint).
Chest Clip
2
Locking Clip:
Not included with
child restraint, see
page 24 or 34
1
Head Pillow
8
Cup Holder
7
Harness
System
5
Tether
4
Seat pad &
Retainer Strips
Replacement Parts
Not available on all models. Styles may vary.
Retainer Strip
3
Lower
Anchor
Connector
Assembly
6
EPS Foam
Body Pillow
Head Foam
9
12
11
10
General
Information
To Next Page
Loading...
