Evenflo Tribute - Installing the Accessories; Care and Cleaning; Proper Disposal of this Child Restraint

42 43
General
Information
• DO NOT use the cup holder to store bottles or hard
containers. Only for use with soft cups (such as
styrofoam or paper).
• DO NOT place any cups that contain hot liquids in
the cup holder.
• DO NOT attach any other items to this child restraint
unless it has been certified for use with this specific
child restraint.
To install the cup holder
A
, peel back the seat pad
B
and insert the hook on
the cup holder into the slot
in seat, as shown. Replace
pad over the seat.
To use the cup holder
A
fold down the lid and swing
the holding arms up.
WARNING
B
A
Installing the Accessories
Not available on all models.
The optional Head Pillow
C
attaches easily and is used
to help support the child’s
head.
Note: Styles may vary.
The optional Body Pillow
D
is used to help support your
child by placing it in the
restraint, as shown.
C
D
• To help protect the vehicle upholstery, place a
towel beneath and behind the child restraint.
• Plastic and metal parts may be wiped clean with mild
soap and water and dried with a soft cloth. DO NOT
use abrasive cleaners or solvents.
• Take care not to damage any labels.
• The harness can be wiped clean with mild soap and
water. Allow harness to air dry. DO NOT immerse
buckle in water or lubricate buckle.
• The seat pad can be machine washed separately in
cold water, delicate cycle, tumble dry 10 – 15 minutes
on low heat.
• NEVER use child restraint without the seat pad.
• Leather pads (not available on all models) may be
cleaned. For best results spot clean with mild soap
and water or with a mixture of 10 parts water to
1 part mild alcohol. Allow to air dry. DO NOT
MACHINE WASH.
Care and Cleaning
Proper Disposal of this Child Restraint
At the end of this child restraint’s useful life, Evenflo
encourages you to dispose of it properly. Most of the
components in this child restraint are recyclable.
1. Remove all fabric and padding.
2. Remove all screws and disassemble the restraint.
3. Recycle all plastic/foam parts and discard the rest.
If your local recycling center won’t accept the padding,
you may dispose of it in the landfill.
Note: Evenflo uses recycled materials in the manufacturing
process whenever possible but never for components that are
critical for safety.