EasyManua.ls Logo

Evenflo Tribute - Positioning the Recline Stand for Forward-facing Use; Installing the Child Restraint Forward-facing with Lower Anchor Connector Assembly

Evenflo Tribute
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28 29
Forward-facing
Forward-facing Upright
The child restraint MUST be in the Upright position
for forward-facing use.
Child MUST weigh 10 – 18 kg (22 – 40 lbs) and be at
least one year of age.
A
Lift the child restraint and
flip the recline stand
A
toward the rear, as shown,
to the Upright position.
Positioning the Recline Stand for
Forward-facing Use
WARNING
Installing the Child Restraint
Forward-facing with Lower Anchor
Connector Assembly
LATCH is a system for attaching the child restraint to your
vehicle seat. It is to be used in place of your vehicle’s seat
belts, and can be used in vehicles with LATCH anchors.
Your vehicle owner’s manual may refer to this system
as ISOFIX, Universal Anchorage System (UAS), or Lower
Universal Anchorage System.
Note: Some vehicle manufacturers have lower
maximum weight ratings for vehicle lower anchor bars,
so you must consult your vehicle owner’s manual or call
the vehicle manufacturer to confirm the limits on your
vehicle’s lower anchor bars.
ONLY use for securing child restraint to vehicle lower
anchor bars.
ALWAYS read and follow exactly the instructions that
accompany your vehicle and child restraint.
NEVER attach two lower anchor connector hooks to one
vehicle lower anchor bar.
DO NOT use the vehicle seat belts to install a child
restraint when using the lower anchor connector
assembly.
This lower anchor connector assembly is intended to be
used ONLY as described in these instructions. Serious
injury or death may result from misuse.
ALWAYS be sure that the lower anchor connector hook
is fully engaged onto the vehicle lower anchor bar by
pulling hard on the lower anchor connector strap. If it
is not totally engaged, the lower anchor connector
assembly will not secure your child restraint. Serious
injury or death may result.
To avoid a strangulation hazard, you MUST store the
unused lower anchor connector assembly, with all slack
removed, in storage area on the back of the seat. Roll
or fold excess lower anchor connector strap and secure
with a rubber band to prevent serious injury to vehicle
occupants.
In addition to these instructions, read and follow your
vehicle owner’s manual regarding installation of child
restraints and LATCH. If there is a discrepancy, follow
your vehicle owner’s manual.

Related product manuals