24 25
D
D
2
Lap Belt Only
Lap & Shoulder
Belt Combination
Pull the seat pad off of the front of the child restraint.
Route the vehicle seat belt
C
through the rear-facing
belt path
D
, continue through the opposite opening
of the child restraint. Fasten the vehicle seat belt, as
shown, depending on your type of seat belt.
Rear-facing
C
C
E
E
3
When the crotch strap
E
is in the front slot, route
seat belt
C
behind the
crotch strap, as shown.
When the crotch strap
E
is in the rear slot, route
seat belt
C
in front of
the crotch strap, as shown.
C
C
Ä
Ä
4
Locking Clip
installed
properly.
13 mm
(0.5 inch)
If your vehicle is model year 1996 or newer, it likely
has a vehicle belt system that can be locked when
tightened, and will not require use of a Locking Clip.
Consult your vehicle owner’s manual before
installing a locking clip.
If your vehicle requires a Locking Clip, please call
ParentLink (see back cover) to obtain a Locking Clip
and instructions on how to install and use it.
Install Locking Clip,
if necessary.
If your vehicle was built prior to
model year 1996, and has either
a lap belt or lap/shoulder belt that is
equipped with an emergency locking
retractor (ELR), you MUST use a
Locking Clip. Check your vehicle
owner’s manual to identify which
vehicle belt system is in your vehicle.
D
C
5
WARNING
WARNING
Ä
Ä
Check your work.
Make certain the belts are tight. If you can move
the child restraint more than 25 mm (1 inch) side to
side or front to back at the rear-facing belt path
D
,
the vehicle belt is not tight enough. If you have not
tightly secured the child restraint, try again, move it
to another location, or install with the lower anchor
connector assembly (p. 19).
• If vehicle seat belts are not routed and fastened
correctly, the child restraint may not protect your
child in a crash.
• DO NOT use this child restraint if it moves more than
25 mm (1 in.) side to side or front to back at the rear-
facing belt path. Serious injury or death may result
from poor installation. If you can not tightly secure
the child restraint, try again or move it to another
location, or install with the lower anchor connector
assembly.
The seat belt must be as tight as possible.
Put your full weight into the child restraint as you
tighten the seat belt
C
.
• Remove Locking Clip from vehicle seat belt when not used
with a child restraint, or the vehicle seat belt will not properly
restrain an adult or child. Serious injury could occur.
To Next Page
Loading...
