9 For Professional Technical Support call 1-844-241-5521
Care and Cleaning
CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug the pump and
allow time for it to cool after periods of extended use.
This pump requires very little maintenance and should provide a long service life. Problems are rare; when the pump flow drops off, the
most likely cause is something solid going down the drain and jamming the impeller.
To clear a jammed impeller:
Unplug the Pump.
Close the discharge shutoff valve.
Bail out the sink as much as possible.
Disconnect the union, unscrew the pump from the sink tail piece, lower the pump to the floor, and slide it out from under the sink (see
Figure 3).
Remove the six housing screws (see Figure 4).
Clean out the pump. Make sure that the pump discharge is clear. If necessary, replace the impeller.
Install the new gasket (included with impeller). Reassemble the pump.
Raise the pump back into position, thread it back onto the sink tail piece, and reconnect the union.
Plug in the pump. Run water in the sink until the pump has run at least one complete cycle to make sure the pump is operating
correctly and there are no leaks.
Figure 4: Remove 6 housing screws to clean out pump
To Next Page
Loading...
Need help?
General
