EverFocus EDN228 - Camera Installation; Basic Installation Steps

EDN228
4
4. Installation
4.1 Packing List
Please check that there is no missing item in the package before installing.
•
Camera x 1
•
Hexagon Wrench x 1
•
Screw with Washer x 3
•
Power Adapter Pigtail x 1
• Screw Anchor x 3
• Cable Gland and Screw Cap x 1
(with one conduit on the inner stopper)
• Software CD x 1
• Sticker x 1
• Quick Installation Guide x 1
• Waterproof Ring x 1
Note:
1. Equipment configurations and supplied accessories vary by country. Please consult your local
EverFocus office or agents for more information. Please also keep the shipping carton for possible
future use.
2. Contact the shipper if any items appear to have been damaged in the shipping process.
4.2 Basic Installation
1. Before screwing the camera to the wall, stick the Sticker on the wall / ceiling to mark the position
for installation. Drill three holes on the wall / ceiling according to the supplied Sticker and push the
supplied three Anchors into the three holes on the wall / ceiling.
2. Unscrew the camera cover and screw the camera base to the ceiling / wall by using the supplied
three Screws with Washers.