NO. DESCRIPTION QTY
15
BOLT (M6 x 14mm)
2
17
CARRIAGE BOLT (M8 X 50MM)
1
22
FLAT WASHER (M6)
2
23
FLAT WASHER (M8)
3
26
NYLON LOCKNUT (M8)
1
52
HEX BOLT (M8 x 50mm)
2
ASSEMBLY STEPS
STEP 7
• Remove the pre-fitted Seat Bracket (12) from the Seat
(42). Fit the Seat Bracket (12) to the Main Frame (4)using
an M8 x 50mm Carriage Bolt (17). An M8 Flat Washer
(23) and an M8 Nylon Locknut (26) tightening securely.
• Fit the Seat (42) to this Seat Bracket (12) using the
previously removed two M6 x 14mm Bolts (15) and two
M6 Flat Washers (22).Then fit the Seat (42) to the Main
Frame (4) using two M8 x 50mm Bolts (52) and two M8
Flat Washers (23)
• The Backrest (41) can be adjusted into 4 positions for
convenient use. (Flat and 3 Inlcine Positions). Please
ensure that the Backrest Adjustment Rod (10) is
positioned UNDER the Backrest Supports and is secured
into place in any one of the 3 adjustment holes in the
Uprights before use.
12
To Next Page
Loading...
