CAUTION
When tensioning, the strap can tear and whip away. Do not stand in the alignment of the
strap. Wear eye protection.
► Press the tensioning button (6) with the
thumb of your right hand.
– The tool pulls it over the seal and the
strap is tensioned until the desired strap
tension is reached. When the tensioning
force is reached, a short green light on the
control panel will indicate this.
– In addition, the set tensioning force and
the status indicator bar with the achieved
tensioning force in relation to the set
tensioning force is displayed.
– The tensioning process is completed
when the status indicator bar is comple-
telylled.
► The tensioning button (6) can now be re-
leased.
► Press the sealing button (7) with the thumb of
your right hand until the seal is notched and
thestrapiscuto.
If the operating lever is pulled too ear-
ly, the display appears orange with
error code and pulsating acoustic
signal (Section 6.6).
– Duringthesealingofthesealthelled-in
dots of the status indicator light up in
sequence and then go out again.
– The end of the sealing process is indi-
cated by an acoustic signal and green
control panel.
6
1
7
2
Evers GmbH Graf-Zeppelin-Str. 10 46149 Oberhausen Telefon +49 208 99475-0 Telefax +49 208 99475-31 evers@eversgmbh.de eversgmbh.de
To Next Page
Loading...
