Telescopic boom Machine ER2500- THE OPERATOR’S
MANUAL
10. If the engine was off on a slope, the emergency braking should be used and
the working arm should be down.
11. When the machine can not move on muddy soft ground, you can try the way
to increase the accelerograph, step down the travel pedal gradually and low the
speed.
1.2.8 TRANSPORT SAFE
1.The multifunctional machine can be transported by truck or similar trailers. Before
proceeding with the operation of load, check if your means of transport has a
appropriate loading capacity. The platform on which the machine is loaded must be
flat to avoid movement.
2.The machine can be loaded or unloaded with the proper load ramps. Make sure the
ramps are strong enough and, if necessary, strengthen them with blocks. Proceed
slowly on the ramps; keep the machine to the center of the platform. The angle of
the ramps must not exceed 25°
3.The machine is endowed with hydraulic traction and can not move when the
engine is off. Therefore the must be driven to a certain position.
4.After loading the machine, prevent the possible steering of the machine by applying
the articulation locking rod.
5.The load and unload must be made on level ground and at a safe distance from
ditches and road edges.
6.After loading the machine, stop it by applying brake blocks to the wheel and the
hand brake. Immobilize it with ropes and chains anchored to the special
junctions(two frontal and two back).
7.After the transport it is recommended to verify the position of the machine do not
constitute a a danger before removing the ropes, the brake blocks and
downloading the machine.
To Next Page
Loading...
