Telescopic boom Machine ER2500- THE OPERATOR’S
MANUAL
15. Always travel with the load in a horizontal position.
16. Cleaning, lubricating or maintenance are forbidden while the machine is in
operation, if needed the above actions must be done after the machine was
stopped, engine off and ignition key taken away.
17. Avoid touching the running parts of the machine.
18. If the machine is believed to be insecure, ask for the intervention of qualified
personnel.
19. Drive the machine on secure grounds; on inclined, wet and slippery grounds
proceed with extreme caution.
20. When in operation in proximity of electrical lines, it is recommended to
maintain the machine in a safe distance.
21. Keep under control your operating area, keep off persons and animals.
22. The acids of the battery is extremely dangerous. Use gloves and protective
masks for eyes.
23. The instruction manual must be read, memorized and kept all the time, in
case of resale and until the machine is dismantled. Should the manual be lost or
damaged, immediately ask for a copy from the manufacture.
24. Before operating the machine, tighten the safety belt and close the door.
1.2.2
KEEP ALARM OF FIRE
1. The fuel or engine oil can be ignited by open fire, specially the fuel is extremely
flammable, keep the fuel or other flammable liquid far away from open fire.
2. The oil tank, pipelines or other flammable parts may get worn out or broken, so it
is forbidden to smoke or light fire around the above mentioned parts.
3. Turn off the engine when add oil.
4. To stock or add fuel or other oils should at an area with good ventilation.
5. If the machine was not equipped with a fire extinguisher, it is necessary to put one
at an easy seen place in the cabin. Make sure the extinguisher is full and
instructions are clear.
6. The fuel and all the lubrication are flammable, so it is forbidden to weld the
pipelines with fuel or lubrication.
7. Fuels and lubricants can be flammable, explosive, toxic and corrosive; hence
stock them in their original boxes out of reach of non-qualified personnel.
8. If the hot parts of machine touch some relative solid, liquid or gas, may cause fire,
To Next Page
Loading...
