Multifunction Machine ER2500- THE OPERATOR’S MANUAL
freezing mixture;
-While the machine is n operation, the operator must sit in the driving seat.
ATTENTION
BEFORE GETTING DOWN FROM THE MACHINE, THE OPERATOR MUST LOWER THE
LIFTING ARM AND THE ATTACHED EQUIPMENT, STOP THE ENGINE AND APPLY THE HAND
BRAKE , STOP THE ENGINE AND REMOVE THE IGNITION KEY.
3.4 SWITCHING OFF THE MACHINE
To stop the machine:
-Make sure the ground where you want to stop the machine is flat;
-Shift the various controls to neutral;
-Free set the accelerator pedal, turn the key to off position and remove it.
Never leave the machine while in operation.
-Apply the parking brake and stop the engine;
3.5 Quick hitch block
The machine has been designed to operate with various attachments that can be
installed on the front arm of the machine and hooked on the quick hitch block (picture
3.5 A ).The hydraulic outlets are located in the front arm.
Picture 3.5 A
To Next Page
Loading...
