Multifunction Machine ER2500- THE OPERATOR’S MANUAL
SECTION 4
MAINTENANCE
4.1 GENERAL INSTRUCTIONS
ATTENTION
-The operating of maintenance and settings must be done when the machine is
switch off.
-Before proceeding with any operation, make sure the machine is on flat ground and
apply brake block to prevent any movement.
-Keep the machine clean, it will help in spotting damaged parts.
-Clean the machine avoiding direct high pressure water jets on the radiator, the heat
exchanger and the engine compartment.
-Before injecting lubricating grease in the grease nipples, it is necessary to clean the
nipples to prevent mud, dust and foreign bodies from contaminating the grease and
making lubrication poor or absent.
-Lubricate and grease every point.
-In restoring or changing the oil, use the same type of recommended oil.
ATTENTION
SHOULD WORK BE NECESSARY WHILE THE ARM OF THE MACHINE IS LIFTED, IT’S
OBLIGATORY TO INSERT THE LOCK, LOCATED ON THE BACK SEAT, TO THE LIFTING
CULINDER IN ORDER TO WORK IN SAFETY.
4.2 ENGINE
Regarding the maintenance works of the engine, carefully follow the instructions of
the engine’s manual.
4.3 AIR FILTER
Clean periodically the air filter (picture 16).
-Remove the filter cap, releasing it from its housing.
-Clean by using a dry air jet with a pressure up to 3kg/cm2, directing the air jet along
To Next Page
Loading...