EVERUN ER2500 - 4.4 COOLING CIRCUIT; 4.6 HYDRAULIC CIRCUIT

Multifunctional Machine ER2500- THE OPERATOR’S
MANUAL
- 24
-
the whole inside surface of the filtering cartridge until the dust is completely removed.
If pressed air is not available, it’s sufficient to beat the cartridge on the palm of the
hand. If the cartridge has greasy spots, wash with warm water and soft detergent;
then rinse with water going from the inside to the outside (pressure up to 2.8 bar). Let
the cartridge drain and dry at ambient temperature. Before reassembling the filter,
check the conditions of the cartridge. If lacerated or worn, it must be replaced. The
cartridge must be replaced after 5-6 cleaning operations and, in any case, every 12
months, or 200 hours.
4.4 COOLING CIRCUIT
Weekly check the liquid level of the radiator. The level must be little below the cap
located under the bonnet.
The liquid is a mixture of water and coolant, suitable for temperature to -25℃. In case
of urgency use only water to top up the mixture level until it becomes possible to
restore the original proportions of water and coolant.
Periodically check the fins of the radiator are clean (if necessary clean with a jet of
air).
4.5 TYRES
Weekly check the pressure and the state of water of the tires, if worn or broken,
replace them.
-Before inflating the tires, always check the condition of the rims and the external
conditions of the tyre to discover the presence of bruises, cuts, lacerations or other
defects.
-Never go beyond the pressure level indicated for the single types of tyres and
always check that the pressure of the right and left tyre are the same.
4.6 HYDRAULIC CIRCUIT
To check the oil level of the hydraulic circuit, lift the loader arm.