Telescopic boom Machine ER2500- THE OPERATOR’S
MANUAL
SECTION 2
General characteristics and technical specifications
2.1 FOREWORD
ATTENTION
The non-observance of what is described in this manual, incorrect operation or
wrongly use the machine and the execution of non-authorized workers, will cause the
exclusion of warranty.
The manufacture declines every and any liabilities for direct and indirect damages
due to the above mentioned points.
For repair and revisions involving works of a certain complexity (motor, hydraulic
plant), it is necessary to turn to the authorized Assistance Center with specialized
personnel or directly to the manufacture, which is available to assure a ready and
accurate technical support to restore the full efficiency of the machine.
2.2 WARRANTY TERMS
1. For the new machine, within determined limits, the manufacture guarantees for a
period of 12 months after bought or 1000 working hours(whichever comes first).
2. The warranty includes repair or replace the parts for free which were proved to be
defective in origin by the technical department of the manufacture.
3. The repair or replacement for the parts should not exceed the warranty period.
4. The warranty is valid on the condition of all the terms listed in the contract was
observed.
5. If any claims happened, the judgement place should be Qingdao city, Shandong
province, China.
2.2.1 EXCLUSIONS FROM WARRANTY
1. Electric, electronics and all those parts replaced due to normal wear are not
To Next Page
Loading...