EVERUN ER2500 - 3.2 BEFORE USE; 3.3 SWITCHING ON THE MACHINE

Multifunction Machine ER2500- THE OPERATOR’S MANUAL
- 20
-
When change the attachments, open the block valve, the plug pin will be retracted
and extend by operating the PTO joystick.
Attention: After changing the attachments, it is necessary to close the block valve.
3.2 BEFORE USE
ATTENTION
-Familiarize with the devices of command and their functions.
-Make sure all protections and covers are correctly installed.
Before starting the machine:
-Check the battery condition. If necessary, try to charge the battery or change it.
-Check the oil engine level (see the instructions of the engine).
-Check the level of fuel (see the indicator 1-picture 9).
-Check the oil level of the hydraulic circuit. A correct level should not lower than the
checking window of the indicator. If the oil level is lower than the red line, then refill it,
that is the indicator should be full of hydraulic oil. When machines and attachments
with cylinders or hydraulic motors are used, the oil level decreases.
3.3 SWITCHING ON THE MACHINE
Before operating the machine, wear the safety belt and close the door. Be
careful while starting the machine for the first time; keep the engine at low
speed.
After all the checks, start the machine by:
-Sitting in the driver’s seat;
-Turning the ignition key to the right activates electric power. A second click to the
right starts the engine;
-Once the engine starts, release the key and let the engine worm up;
-Should the engine fail to start, wait some seconds and retry;
-The original anti freezing mixture allows use of the machine to minus 20°;
-If the external temperature is below 0° and the radiator is not supplied with anti
freezing mixture, discharge the water and charge the radiator with proper anti