Multifunction Machine ER2500- THE OPERATOR’S MANUAL
ATTENTION
Before hooking, unhooking or using attachments, it is necessary to consult the
relative instructions manual, lay down the accessory and stop the engine.
The attachments must have proper protection.
To assemble the equipment follow these steps:
-Drive the machine close to the equipment;
-Gradually draw near to the equipment, turn the attachment plate, make the two
plates are parallel.
-Hook the two pins of the block to the two upper points of the attachment;
-Slightly lift the arm by shifting the joystick to (B), push forward the hydraulic lever
until the lower pins lock them. After confirm the two pins were locked, the hydraulic
lever returns to neutral position.
-Connect the hydraulic pipelines to the designated quick hitch block, and follow the
instructions of the attachments manual.
-To detach or replace the attachments, follow the “attachment instructions”
backwards.
ATTENTION
Do not leave the machine with the arm lifted and loaded, but lay the
arm down after discharged.
DON’T USE THE MACHINE ON UNEVEN AND LEANING GROUND
To Next Page
Loading...
