Evh HARDEE LR50160 User Manual

Section 4
Hardee by EVH
Operation Instruction
______________________________________________________________________________________
LR50160 Long Reach Mower 14
Figure 6 shows the two sets of bolts, nuts and
washers that go on the “HINGED GATE”. Bolt A is
used to lockdown the hinged gates to the LR50160
DECK when cutting trees and bolt B is tightened onto
the deck for storage during the tree-cutting process.
DANGER
Never attempt to use the cutter to remove brush or
trees larger than 4 inches in diameter. Failure to use
caution when cutting trees, may lead to the tree
falling on the cutter deck and tipping the tractor over.
We recommend removing small sections at a time,
no more than two or three feet in length per pass.
See fig. 5.
Unhook and Post Use Care
Before unhooking the tractor from your mower, always
clean the unit thoroughly to remove any grass, mud or
debris. This mower should always be stored on a hard
level surface.
Unhooking the LR50160
 To unhook from your unit, first lower all jack stands
to the storage position.
 Lower the tractor lift arms so that the mower will rest
firmly and evenly on all jack stands.
 Lower the boom arms and mower deck so that they
too rest firmly on the ground.
 Be sure to relieve all hydraulic pressure on the boom
arms and deck before unhooking.
 Disconnect driveshaft from tractor.
 Disconnect joystick cable at the bulkhead connector
on the wire cover box.
 Unhook tractor hitch from 3-point frame on mower
POST USE CARE
 Never leave the driveshaft hanging down and
touching the ground.
Figure 5
Figure 6

Evh HARDEE LR50160 Specifications

General

Brand	Evh
Model	HARDEE LR50160
Category	Lawn Mower
Language	English