15
OIL AND FUEL
OIL AND FUEL
OILING SYSTEM
FILLING THE OIL TANK
Release the port and starboard engine cover
latches by turning each handle downward.
Pull up on the tilt handle to release the engine
cover seal on the engine cover.
1. Tilt handle
Remove the engine cover to access the oil
tank.
Remove the filler cap and fill the tank with the
recommended outboard lubricant, as speci-
fied in Oil Requirements on page 16.
Replace the filler cap and tighten securely.
Reinstall the engine cover.
IMPORTANT: The oil tank capacity is 2.5
quarts (2.4 liters).
If the “LOW OIL” warning light illuminates,
you have approximately five hours of normal
operation before running out of oil when us-
ing TC-W3 oil. If using
Evinrude/Johnson
XD100™ oil, you have approximately ten
hours of normal operation remaining. Refill
the onboard oil tank at next convenient op-
portunity.
IMPORTANT: Always “top off” your oil tank
prior to prolonged usage or long trips.
1
To Next Page
Loading...
