314
GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
gearcase. Align and level gearcase assembly in
fixture as shown. Secure fixture to floor press.
Housing must be completely seated in gearcase
to install retainer tabs. Depth to retainer tab sur-
face on bearing housing is approximately
1 in. (25.4 mm).
Install two retainers, washers and screws. Apply
Ultra Lock to threads and tighten screws to a
torque of 18 to 20 ft. lbs. (24 to 27 N·m).
Propeller Shaft Bearing Housing
and Gear Installation – “M2” Type
IMPORTANT: The propeller shaft bearing hous-
ing on the “M2” type gearcases is PRESSED into
the gearcase housing.
Oil and install thrust bearing and thrust washer on
hub of reverse gear. Slide the gear assembly onto
the propeller shaft until it engages the pinion gear.
Lightly apply Triple Guard Grease to new bearing
housing O-rings. Install O-rings in grooves in the
housing. Grease the machined side surfaces of
bearing housing.
006844
006845
1. Retainer tab screws 001989
1. Thrust bearing
2. Thrust washer
006925
006924
To Next Page
Loading...
