EVISTR VOICE RECORDER
http://blog.evistr.com support-us@evistr.com
Page - 18 - of -28 -
CHAPTER THREE
V508 Advanced Operation Guide
1) Record Settings
1.1 Record Format
When entering “Record Format”, it offers WAV/MP3 for choice.
1.2 Set Bit Rate
The bit rate can set based on format
Recording Bit Rate (recording time at 16GB)
1.3 Voice Activated Recording (Track AVR Mode)
What is Voice Activated Recording?
When select AVR mode ON, and set the avr level. Press REC, screen will display VOX information,
it means the device successfully enter voice activated recording mode.
When voice activated recording is on, the recorder will only capture loud enough voice, for too
low decibel voice, it will neglect.
So it saves device storage space, and save power, reduce blank snippets in recordings, and
reduce playback time.
How to Use this Function?
When AVR mode is on, we also need to select the desired voice activated sensitive level, so the
voice activated recording function could perform properly as desired.
It could select from level one to level five
Level six, is the mostly dumb level, it means the mic will be less sensitive, need louder voice to
active the recording, otherwise, the recording time is not counting, and it was pause recording.
While level one, is the mostly sensitive level, it means the mic is very sensitive, just a soft
speaking will be captured. It will be almost continuously recording, cannot see pause status.
NOTICE:
When voice activated recording is on, during recording screen will show VOX
To Next Page
Loading...
