EVISTR VOICE RECORDER
http://blog.evistr.com support-us@evistr.com
Page - 8 - of -28 -
Recorder will not make any noise during recording, except Record LED light flash (this function
could turn off)
Keep this EBOOK and its Booklet in the package safely for future reference
Customer satisfaction and warranty is our mostly important thing. Any issues, just directly
contact us support-us@evistr.com
Contact customer service with ORDER ID or System Firmware Version Information, Bar Code on
the package, so you will get more effectively reply
Register VIP service, get gifts free, extend warranty, effectively customer service
DON’Ts
Do not scratch the device body, and writing near the device microphone, it is very sensitive, all
this small noise will be capture very clear and loud
Do not format the device unless the file had backup
Do not delete file unless the file had backup
Do not press any buttons when connect to computer, in case exiting connection mode
Do not use non-original micro USB cable to transfer data from device to computer, not all kind
micro USB support data transfer function
Do not use the Voice Activated Function, unless you need, otherwise it may neglect recording
some low decibel voice you need
Do not pause the device from long time, the device will automatically shut down when there is
no operation, and not playing or recording
CHAPTER TWO
V508 Basic Operation Guide
1) Charging Voice Recorder
Connect it to your computer with enclosed cable, it will charge, once it has finished charging
( typically around 1.5-2 hours), you can eject the device from the USB port
You could also connect the enclosed cable with your voice recorder and other USB socket for
charging (like USB wall charger, USB charge dock, power bank etc)
Charging Input: 5V 500mAh ~ 1000mAh
To Next Page
Loading...
