EWM Taurus 551 Basic FDG - Page 53

Rectifying faults
Error messages (power source)
099-005149-EW501
11.08.2016
53
Error
(Err)
Category
Possible cause
Remedy
a)
b)
c)
60
-
-
x
Software update required
Inform Service.
Legend for categories (reset error)
a) The error message will disappear once the error has been rectified.
b) The error message can be reset by pressing a push-button:
Welding machine control
Push-button
RC1 / RC2
Expert
Expert 2.0
CarExpert / Progress (M3.11)
alpha Q / Concept / Basic / Basic S / Synergic /
Synergic S / Progress (M3.71) / Picomig 305
not possible
c) The error message can only be reset by switching the machine off and on again.
The shielding gas error (Err 6) can be reset by pressing the "Welding parameters" key button.