EXCELL PRECISION CO., LTD.
0201813X ZSME300000366
Preset Single point (preset low limit only):
After “preset low limit” procedures is completed and the display shows . ,
then press key again, the display shows . . This means that the “preset
single point” procedure is completed.
NOTE
_ _ _ x x
A B
A Setting for the status that LCD is on and the beeper beep:
0 = when stable, the beeper beeps and LCD is on.
1 = when stable, the beeper beeps; whether stable or not, LCD is on.
2 = whether stable or not, the beeper beeps and LCD is on.
3 = open warning device: when the weight is higher than HI value and the weight is
stable, LCD is on and Relay Card open.
B Setting for the beep status:
0 = No beep
1 = OK (when the weight is over Low Limit & under or equal to High Limit.), the beeper
beeps.
2 = When the weight is under or equal to Low Limit & over High Limit, the beeper beeps.
Under Status in Preset Low Limit (preset single point only)
The BEEP, LCD mode should be fixed as follows:
When over “Low Limit”, the beeper beeps and is off
Whether stable or not, the beeper beeps and LCD indication is on
Warning device setting (not available in 4/5 key models)
Set HI value and value of the beep, LCD mode should be fixed as follows:
A
When the weight equals to HI value, Relay Card open and the weight is accumulated. Press CE
key to dismiss the warning sound and the range of accumulated weight is [000.000]~[999999].
Clear warning accumulation (not available in 4/5 key models)
Press key first and then press key to clear all accumulated data.
Accumulated data is cleared automatically under following conditions
a. when shift among weight mode, counting mode and warning accumulation mode.
b. when shift the units
c. turn off the scale
Set relay low output: L1 => low output; L0=> no low output
LCD indication:
10d Low Limit High Limit
◆ To exit preset mode, please press key.
2. Recall Check-weighing Values (not available in 4/5/10 key models)
Press key then press key Recall “Low limit value”
Then press key again Recall “High limit value”
Then press key again Recall “Beeper value”
Then press key again Back to the beginning
To Next Page
Loading...
Need help?
General
